Search
spacer
   
Categories
spacer
Categories
HiFi Products  (313)
Accessories  (5)
Amplifiers & Preamps  (152)
Cables  (46)
CD & SACD Players  (43)
DAC  (4)
Hifi Rack  (14)
Power Conditioner  (7)
Speakers  (42)
Tubes  (0)
MeiXing MC-2A3 Valve tube Pre Amplifier(Special Class)
mex-2033-01027-p.jpg
$1,092.00

Product # : mex-2033-01027
This item is shipped via DHL Express, 2-3 Business Days,
see details. The cost is $255.68
Multi-item order may have less shipping cost for each item.
Availability
In stock
Ask Questions
Parameter
Input Sensitivity: 1000MV
Gain: 20dB
Input Impedance: 100K
Output Impedance: 600ohms
Total Harmonic Distortion: 0.5%
Frequency Response: 5Hz-150KHz
S/N: 92dB
Input Jacks: 4 groups
Output Jacks: 2 groups
Vacuum Tubes: 2A3C*2 EL34*1 6SN7*3 ECC88*3
Supply Voltage: AC220V/50HZ AC110V/60HZ
Power Consumption: 80W
Dimensions: 36.5L*44.5W*23H(cm)
Weight: 21.5kg
With remote control.
Write an on-line review now!
(With 5 stars being the best)
5 stars MC-2A3 Review Update, 2008-10-07
Reviewer: Jim, from North Carolina, United States
I have done a minor circuit change and replaced the several caps to transform this very good unit to an amazing preamp. Details can be found at: http://db.audioasylum.com/cgi/m.mpl?forum=amp&n=137469&highlight=mc-2A3&r=&session= The sound is much cleaner across the board. The bass is much more natural. I can clearly hear all the bass notes. Before the bass was stronger but somewhat distorted. I compensate for the bass by turning up my woofer plate amps a bit. The best way to describe the changes are now a good vinyl recording being played sounds much more like live music. Below are the changes I did: *Replace all the tubes except for the 2A3C. *Do the small circuit change. *Replace the output caps with 3.3uF Mundorf silver oil. *Use Two 47uF VALAB caps for the 6922 section. *Use one Solen 47uF cap and one Solen 36uF cap in parallel for the 6SN7 section (not enough room for more). I give this mod my highest recommendation. Jim
5 stars Amazing!, 2008-08-26
Reviewer: Jim, from Asheville, North Carolina, United States
I just received the MC-2A3 yesterday and am blown away with the improvement! The double boxed packaging was first class and the unit is in perfect condition. I opened the bottom up (thick sheet steel cover)and the quality/workmanship is the as good as I have ever seen. I installed different tubes than came with the stock unit per online recommendations (Mullard, Tung-Sol, JAN military grade. The stock 2A3C tubes do not need replacing. Without break-in I noticed the MC-2A3 was a huge improvement over my current DIY Welborne Ultrapath BP (very nice unit) in all aspects including: *Midrange much more lifelike, clear, and smooth *The highs are more pronounced but not fatiguing at all. *Much more dynamic bass. *The added gain is a plus as my current Welborne Terraplane 300B monoblocks only put out 7 watts per channel. *Dead quiet. *Absolutely beautiful but huge pre-amp. *The on/off switch does not have the best action but is still ok. *It does not have a balance control which is important to me. So far this has not been an issue with this unit. I will give an update later once it is broken in.
5 stars MeiXing MC-2A3 Valve tube Pre Amplifier, 2007-11-07
Reviewer: SLW, from South Carolina, United States
This is the best tube amp I have ever listened to, which came as a total surprise!! I read many views and reports on the internet about the fine qualities of the Ming Da preamplifiers, so I finally succumbed and purchased the MC-2A3. It is truly a behemoth in form and performance! I use monoblock 300B amplifiers and vintage Tannoy speakers. With the MC-2A3, the soundstage is larger, the sonic quality(tonality) is smooth, crisp, and detailed. Excellent bass and superb throughout the audio spectrum. Actually, I was blown away. Unbeatable price and performance. Delivered promptly and securely packaged. Very good support frm NY sound.
5 stars MC 2A3, 2007-03-29
Reviewer: Sigurd Lundh Limtun, from OSLO, -, Norway
I ordered from you a Mingda pre MC2A3. I received it in good order, and the sound is beautiful. Great finish, solid built. I use Electrocompaniet UP CD player and EC AW 120 end stage with it. Great ! Thank you for good and quick service. ! Best regards Sigurd Limtun Oslo, Norway
5 stars , 2006-12-05
Reviewer: Stephan, from United States
I own this preamplifier for a month with great satisfaction. Outstanding build quality. Perfect musical harmony with Acoustat 2+2, 2 Parasound 1500A , Hand made LP player and Sony 999ES digital source. Dynamics, and lifelike smoothness from top to bottom world class. Cracked plastic cover was replaced without the fuss. Thanks.
5 stars A real gem!, 2006-03-31
Reviewer: Steven Medel, from New York, New York, United States
Hello! I think it is a real shame that this beautiful Preamp, is unknown here in the U.S. It is beautifully made weighing in at a hefty 47.3 pounds! It is the first Preamp that I have run across, that uses Poweramp tubes (two 2A3 tubes and an EL34). I have no doubt that if this Preamp was made in the U.S., it would cost at least $3000.00 based on its sound quality and build! At $1200.00 it is a steal! I wish Ming Da would market their products here, but I am sure a U.S. distributor would double the cost. Buy it here at N.Y. Sound while you can, because I believe N.Y. Sound is the only importer of this Preamp here in the U.S. I have not seen it anywhere else.